I find the processes used in the workshop fascinating, and though others might enjoy it if I share some of them here. Today we look at the steps taken from start to finish to create one type of finish: a slightly distressed thick black lacquer finish with hand rubbed edges.
|Step two: After the lacquer has been given sufficient time to properly dry, edges are scraped away, down to the bare wood, with a dull blade or scrapper.|
Edges and any other protruding surfaces are then scraped again this time using the flat portion of the blade to create and irregular effect and to imitate wear and tear.
Since each piece is hand rubbed, no two will ever be exactly the same and this is a highly subjective process which varies depending on the overall structure of the item.
Depending on the structure of the piece, one would normally scrape away areas of heavy use, joints or areas likely to be easily rubbed over the years in passing. If the intended look is just distressed, this will suffice. For an actual “antiqued” effect, the the bottom areas would require more attention as these areas would normally be subject to more wear and tear. Opinions may vary on what is “natural looking” and whats not depending on the artisan and the intended recipient.
Step three: Lots of gentle hand sanding to smooth out any hard contrast between the lacquer and the bare wood as well as to increase the “naturally occurring” distressed feel. This looks much easier then it is and takes quite a bit of time to smooth out the edges of the tick dried lacquer.
|Step four: A brown stain is then hand applied to the exposed bare areas of wood. The actual color of the stain may be darker or lighter depending on the desired effect. In this case we used a darker brown for that slightly worn look.|
The final result: A beautiful slightly worn finish with just enough character and its own unique hand crafted beauty.